Heating and cooling controlled via a GSM gateway

Forum for ZhiDou D1 electric vehicles
Post Reply
Andytech3
Posts: 24
Joined: Tue Dec 16, 2025 6:25 pm

Heating and cooling controlled via a GSM gateway

Post by Andytech3 »

I’ve been toying with this idea since the summer, when I had to crank the air conditioning and ventilation to 100% for at least 2–3 minutes every day before leaving work—just so I wouldn’t roast in the car on the way home (Leaving the windows cracked open by about 2 cm for the entire shift didn’t really help much either :D ) . And the final decision came only now, as winter begins, when I watched my wife from the window laboriously scraping frost off the windshield :roll: .

I ordered this GSM gateway from AliExpress, made by WLTE Control. It features 4x changeover relays, 4x universal inputs, and 2x temperature sensors (it’s also available with a temperature and humidity sensor, but that seemed unnecessary to me).Specifically, the SM4-WLTE model for €65
3.png

As a first step, the wiring in the fuse box located in the engine compartment must be modified. In the original configuration, the air conditioning and heating can only be activated once the ignition key is turned to the second position and the "READY" indicator light illuminates—that is, after the main B+ contactor inside the fuse box has been engaged.
Unscrew both nuts on the contactor and remove the cable with a lug—marked in yellow—from the bottom terminal. You can screw the nut back on.
1.png

Next, attach this cable (with its lug) to the upper contact of the contactor and screw the nut back on. (Tighten the nuts firmly, but use COMMON SENSE! Firmly, because 250 to 320A of current flows through it. And with common sense, because the threaded insert is merely embedded within the contactor's plastic housing.)
2.png

We have now ensured that the HV power supply will be available once the B-contactor inside the battery engages.

The next step is to power up the vehicle using a 12V supply, which is needed to wake up the BMS, the climate control panel, and the fan. During the conversion process, I also discovered that a +12V feed is required for the heating contactors (the climate control panel grounds them to engage them; the +12V likely comes from the VMS once the B+ contactor in the fuse box has closed—presumably to ensure that high-voltage power isn't routed to the heater through the pre-charge resistor and pre-charge relay).

First, we prepare the GSM gateway itself, including the power supply for the unit and its peripherals, as well as the relay connections using the NO (Normally Open) contacts for relays 1, 2, and 3. I sourced the GND and Batt+12V connections from the connector—located on the right-hand side under the dashboard—where the original GSM gateway for the SharenGo system was previously connected. This circuit is protected by a 10A fuse located in the engine bay near the wiper motor, so no additional fusing is required.
5.png

The first step in the sequence for activating the car's heating/cooling system is to supply +12V to the BMS, which then engages the B- contactor within the battery. The best connection point for this is the wiring leading to a module that monitors the 12V battery voltage; if the voltage drops, this module activates the BMS, allowing the DC/DC converter to recharge the 12V battery even when the vehicle is switched off. This module is located near the fuse box under the steering wheel on the driver's side. It is a small, black, encapsulated unit containing a relay and a green LED, with four wires connected via a 4-pin connector: two white wires, one brown wire, and one red wire.


I am continuously editing and adding to the article .......
Post Reply